torrent in site, but our connection between the remote machine and the desktop client is a success! Click Add.īack in the Connection Manager, you’ll see the entry for the Raspberry Pi (in my case PI and my pwd) if all goes well, the indicator light will turn green.Ĭlick Connect and you’ll be kicked into the interface, connected to the remote machine: You’ll need to input the IP address of the Raspberry Pi on your network, as well as the username and password you set during the earlier configuration. Click the Add button in the Connection Manger and plug in your Pi’s info like so: Here is where you input the information about your Raspberry Pi and the Deluge installation. This time when Deluge starts, it will present you with the Connection Manager. Ĭlick OK and then restart the Deluge desktop client. Within the interface submenu, you’ll see a check box for “Classic Mode”. Once launched, navigate to Preferences -> Interface. Once you have installed the Deluge desktop client, run it for the first time we need to make some quick changes. Hit up the Deluge Downloads page and select the installer for your operating system. We need to install the Deluge desktop client in order to finish the configuration. Now it’s time to kill the daemon and restart it one more time so that the config changes take effect:Īt this point your deluge daemon is ready for remote access. This enables remote connections to your Deluge daemon and double checks that the config variable has been set. Once you’re inside the console, we need to make a quick configuration change. If starting the console gives you an error code instead of nice cleanly formatted console interface type “exit” and then make sure you’ve started up the daemon. Once you’ve saved them, start up the daemon again and then the console: For our purposes, we used pi:raspberry:10.When you’re done editing, hit CTRL+X and save your changes. Where in user is the username you want for Deluge, password is the password you want, and the level is 10 (the full-access/administrative level for the daemon). Once inside nano, you’ll need to add a line to the bottom of the configuration file with the following convention: Sudo apt-get install deluged deluge-console deluge-webĬp ~/.config/deluge/auth ~/.config/deluge/auth.old
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |